SMR
High-voltage dividers
High-voltage dividers are used to measure voltages and decouple partial discharges in high-voltage test systems. Depending on the specific type, they are used to measure alternating voltage (AC), direct voltage (DC), lightning impulse voltage (LI), and switching impulse voltage (SI) systems. High-voltage dividers by HIGHVOLT comply with the relevant IEC standards. The systems are available for both indoor and outdoor use.
Your Advantages at a Glance
-
Special resistor for measuring lightning voltages (LI)
-
Cost-effective, robust design
-
Movable by means of rollers or air cushions, which can be attached to the base
-
Divider is calibrated in the HIGHVOLT calibration laboratory according to IEC 60060-02 and then receives a DakkS calibration certificate
Product Information
- Controlled resisitve lightning impuls reference voltage divider
- Precise measurement of front or front chopped lightning impulse voltages (LI)
- Fulfills all requirements of IEC 60060-2:2010
Application
- Controlled resisitve lightning impuls reference voltage divider
- Precise measurement of front or front chopped lightning impulse voltages (LI)
- Fulfills all requirements of IEC 60060-2:2010
